SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL
AUDI A3 03 DIESEL
MAKE MOD. YEAR
X
ALARM/SIREN Position the compact alarms and the sirens on the support near the locking of the bonnet.
POSITION
Position the modular sistems and the modules under the central tunnel or under the
CENTRAL UNIT POSITION
passenger s side seat.
POWER SUPPLY +30: connect directly to the positive pole of the battery.
-31: connect directly to the ground terminal located behind the driver s side sill cover.
IGNITION WIRE +15/54: connect to the 2 mm2 BLACK wire, in the wiring harness coming out of the fuse box
located on the left side of the dashboard.
DIRECTION INDICATORS Connect to the BLACK/WHITE wire at the position nr. 11 and to the BLACK/GREEN wire at
the position nr. 9 located in the 21 way light brown connector, marked D ; BLACK/GREEN
wire at the position nr.10 in the black connector marked B ; BLACK/WHITE wire at the
position nr.11 in the light brown connector, marked C and to the BLACK/WHITE wire at the
position nr.8 and to the BLACK/GREEN wire at the position nr.6, in the 12 way black
connector, marked A . To make the connection it is necessary to separate the lines by means
of diodes.
CENTRAL DOORS LOCKING Negative control signal
Connect with both unlock and lock wires (VIOLET and ORANGE) of the antitheft and to the
BLUE/WHITE wire, at the position nr.13, in the 20 way black connector, directly inside the
driver s side door. As alternative, you can find the same wires in the wiring harness coming out
of the central locking motor of the central locking unit, inside the driver s side door.
Note: it is necessary to insert a 180 Ohm resistance in serie to the ORANGE wire of the
antitheft. Refer to the fitting diagram nr.200.
IMMOBILISATION POINT Gasoil pump
Cut the 1 mm2 BLUE/BLACK wire at the position nr.27, behind the fuse box.
STARTER +50: Cut the 0,35 mm2 RED/BLACK wire, at the position nr.1, in the 12 way black connector,
marked G , in the central located under the driver s side dashboard.
BONNET SWITCH Connect to the BROWN/LIGHT BLUE wire, in the wiring harness coming out of the bonnet
lamp.
DOORS SWITCH Connect to the BROWN/WHITE wire in the wiring harness behind the lateral bulkhead, driver s
side.
BOOT SWITCH Connect to the BLACK/RED wire, at the position nr.8, in the wiring harness coming out of the
17 way light brown connector, in the central located in the rear covering of the passenger s
side boot.
aua303gbd.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
FITTING DIAGRAM NR. 200
Diagram to connect the diode to make central unlock and lock on
AUDI A3 year 2003
ORANGE VIOLET ORANGE/WHITE
VIOLET/WHITE
ground
180 Ohm resistance
Driver s side door
switch
1N4004 diode
Towards the central
BLUE/WHITE at the position nr.13, in the 20 way black connector of the central
of the windows activating central, directly inside the driver s side door.
ground
aua303gbd.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
Wyszukiwarka
Podobne podstrony:
Serie 7 2003 diesel NOA4 2003 diesel NOA3 2003 diesel YES530 2003 petrol NOA3 1998 petrol NOSerie 3 2003 diesel YESA2 2004 diesel NOA4 2003 diesel YESAudi A6 2003 DieselAudi A6 2003 Dieselwięcej podobnych podstron