SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL X
BMW SERIE 3* 01 DIESEL
MAKE MOD. YEAR.
* Models with original equipment keyless entry system.
ALARM/SIREN Position the compact alarms and the sirens in the engine compartment, on the steering
POSITION column.
CENTRAL UNIT POSITION The modular systems and the modules should be positioned behind the right lateral glove
compartment under the dashboard, passenger s side.
POWER SUPPLY + 30: connect to the 4 mm2 WHITE/RED wire located in a multiway connector at the
entrance of the fuse box.
- 31: Connect with a cable terminal to one of the original ground terminals located behind
the left lateral bulkhead , driver s side.
IGNITION WIRE + 15/54: Connect to the 2 mm2 GREEN/RED wire located in the wiring harness behind
the left lateral bulkhead, driver s side.
DIRECTION INDICATORS The electric system of the car has the direction indicators lines divided, so connect to the
following wires using 4 diodes:
(ant. left) BLUE/GREEN at the position nr.50, (ant. lat.) BLUE/YELLOW at the posiion
nr.18, (post. left) BLUE/GREEN at the position nr.1, (ant. right) BLUE/ BROWN at the
position nr.11, (ant. lat.) BLUE/YELLOW at the position nr. 3 and (ant. right)BLUE/BROWN
at the position nr. 43 located in the 54 way black connector placed in the module integrated
to the position/antidazzle lights control switches
ELECTRIC WINDOWS Comfort closing
Negative control signal
The closing of the electric windows is obtained timing the BLUE/RED closing wire located
at the position nr. 22 in the connector coming out of the central doors locking unit, behind
the glove compartment, passenger s side
ACTIVAT./DEACTIVATION Connections antitheft/vehicle
CONTROLS Art.38XX Vehicle Position
YELLOW/BLACK LIGHT BLUE motor coming out central doors locking unit
GREY/BLACK WHITE motor coming out central doors locking unit
VIOLET/WHITE GND car body
ORANGE +30 in the fuse box
VIOLET WHITE/BLACK wiring harness inside driver s side door
ORANGE/WHITE +30 in the fuse box
Note: Cut the WHITE/BLACK wire after having programmed the on/off controls of the
antitheft.
IMMOBILISATION POINT Fuel pump
Cut the 1,5 mm2 GREEN/VIOLET wire located in the wiring harness coming out of the fuse
marked nr. 18, in the fuse box, in the engine compartment.
STARTER +50: Cut the BLACK/LIGHT BLUE wire located in the wiring harness coming out of the
ignition key.
BONNET SWITCH Install an additional switch on the front headlamp support grill, driver s side.
DOORS SWITCH Connect to the 0,5 mm2 RED/BLUE wire located in the wiring harness coming out of the
connector of the central doors locking unit located behind the glove compartment,
passenger s side.
Attention: this is a positive control signal, it is suggested to reverse the polarity by means
of a microrelay.
BOOT SWITCH Connect to the WHITE/BROWN wire located in the wiring harness behind the sill cover,
driver s side.
bmse301gbbt.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
Wyszukiwarka
Podobne podstrony:
serie 5 2001 petrol YESPT CRUISER 2001 petrol YESserie 5 2001 diesel YESA2 2001 petrol YES166 2001 petrol YESA4 2001 petrol YESX 5 2001 petrol YESPT CRUISER 2001 petrol NOwięcej podobnych podstron