ïż
NO.14 ENGINE FLARES UP OR SLIPS WHEN UPSHIFTING OR DOWNSHIFTING
NO.14 ENGINE FLARES UP OR SLIPS WHEN UPSHIFTING OR DOWNSHIFTING
B3E050319090W18
14
Engine flares up or slips when upshifting or downshifting
DESCRIPTION
• When the accelerator pedal is depressed for driveaway, engine speed increases but vehicle speed increases slowly.
• When the accelerator pedal is depressed while driving, engine speed increases but the vehicle does not.
POSSIBLE CAUSE
• There is clutch slippage because the clutch is stuck or the line pressure is low.
1. Clutch stuck, slippage (forward clutch, 3-4 clutch, 2-4 brake band, one-way clutch)
• Line pressure low
• Shift solenoid D malfunction
• Shift solenoid E malfunction
• Shift solenoid A malfunction
• Shift solenoid B malfunction
• Shift solenoid C malfunction
• Pressure control solenoid malfunction
• Body GND malfunction
• Accelerator cable mis-adjustment
• Control valve body malfunction
2. Signal malfunction
• Vehicle speed sensor malfunction
• Sensor GND malfunction
• TP sensor malfunction or mis-adjustment
• Input/turbine speed sensor malfunction
3. Poor operation of mechanical pressure
• Selector lever position disparity
• TR switch position disparity
Note
• Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.
Diagnostic procedure
STEP
INSPECTION
ACTION
1
Is shift point normal?
Yes
Go to the next step.
No
Go to No.9 "ABNORMAL SHIFTING".
2
Inspect the value at the following PCM PID using the WDS or equivalent. (See PCM INSPECTION [Z6].)
• TP
Is the PID value normal?
Yes
Go to the next step.
No
Repair or replace any malfunctioning parts.
3
Disconnect the PCM connector.
Is the resistance between the ground terminal at the PCM connector and the body ground less than 5.0 ohms?
Yes
Go to the next step.
No
Repair the open ground circuit. Reconnect the PCM.
4
Inspect the LPS PID value.
Is the LPS PID value normal?
(See PCM INSPECTION [Z6].)
Yes
Overhaul the control valve body and repair or replace any malfunctioning parts. (See ATX workshop manual (FN4A-EL).)
If any problem remains, overhaul the transaxle and repair or replace any malfunctioning parts. (See ATX workshop manual (FN4A-EL).)
No
Repair or replace any malfunctioning parts.
5
• Verify the test results.
- If normal, return to the diagnostic index to service any additional symptoms.
- If the malfunction remains, inspect the related Service information and perform repair or diagnosis.
• If the vehicle is repaired, troubleshooting is completed.
• If the vehicle is not repaired or additional diagnostic information is not available, replace the PCM.
Wyszukiwarka
Podobne podstrony:
B3E050001030T03B3E050219090W02B3E050319090W05B3E050219090T09B3E050319090W11B3E050001030T01B3E050319090W34B3E050219090W09B3E050219090W01B3E050219090W16B3E050219090T03B3E050219090T07B3E050219090W12B3E050319090W19B3E050219090W06B3E050319090W28B3E050219090W27B3E050219090W13B3E050219090W29więcej podobnych podstron