The Loopback Root Filesystem HOWTO: Other Loopback Root Device Possibilities
4. Other Loopback Root Device PossibilitiesOnce the principle of booting a filesystem in a file on a DOS partition has been
established there are many other things that you can now do.4.1 DOS Hard-disk Only InstallationIf it is possible to boot Linux from a file on a DOS harddisk by using a boot
floppy then it is obviously also possible to do it using the harddisk itself.A configuration boot menu can be used to give the option of running
LOADLIN from within the AUTOEXEC.BAT. This will give a much
faster boot sequence, but is otherwise identical.4.2 LILO Booted InstallationUsing LOADLIN is only one option for booting a Linux kernel. There is
also LILO that does much the same but without needing DOS.In this case the DOS format floppy disk can be replaced by an ext2fs format one.
Otherwise the details are very similar, with the kernel and the initial ramdisk
being files on that disk.The reason that I chose the LOADLIN method is that the arguments that
need to be given to LILO are slightly more complex. Also it is more
obvious to a casual observer what the floppy disk is since it can be read under
DOS.4.3 VFAT / NTFS InstallationI have tried the NTFS method, and have had no problems with it. The NTFS
filesystem driver is not a standard kernel option, but you must use the patch
from Martin von Löwis which is available from his web page. http://www.informatik.hu-berlin.de/~loewis/ntfs/. This is alpha
software and requires a patch to the kernel which is not quite trivial but not
too difficult.The only changes for the VFAT or NTFS options are in the initial ramdisk, the
file /linuxrc needs to mount a file system of type vfat or ntfs rather
that msdos.I know of no reason why this should not also work on a VFAT partition.4.4 Installing Linux without Re-partitioningThe process of installing Linux on a PC from a standard distribution requires
booting from a floppy disk and re-partitioning the disk. This stage could
instead be accomplished by a boot floppy that creates an empty loopback device
and swap file. This would allow the installation to proceed as normal, but it
would install into the loopback device rather than a partition.This could be used as an alternative to a UMSDOS installation, it would
be more efficient in disk usage since the minimum allocation unit in the ext2
filesystem is 1kB instead of up to 32kB on a DOS partition. It can also be used
on VFAT and NTFS formatted disks which are otherwise a problem.4.5 Booting From a Non-bootable deviceThis method can also be used to boot a Linux system from a device that is not
normally bootable.CD-RomZip DisksParallel port disk drivesObviously there are many other devices that could be used, NFS root filesystems
are already included in the kernel as an option, but the method described here
might also be used instead.
P