SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL X
VOLKSWAGEN GOLF 4 98 DIESEL

MAKE MOD. YEAR
ALARM/SIREN Position the modular system and the siren in the engine compartment, on the
bulkhead between the engine compartment and the cabin. Run the cables
POSITION
through the available rubber plug located under the brake fluid reservoir.
CENTRAL UNIT POSITION Position the modular systems and the modules under the dashboard on the
driver s side. Alternatively, behind the left-side bulkhead on the driver s side.
POWER SUPPLY + 30: connect with an eyelet terminal to the pin marked  +30 of the terminal strip
located on the lower part of the fuse box.
- 31: connect with an eyelet terminal on the grounding shunt up on the left of the
fuse box.
IGNITION WIRE Connect to the 2 mm2 BLACK wire in the central area of the fuse box located on
the left-side bulkhead on the driver s side.
DIRECTION INDICATORS Connect to the 1 mm2 BLACK/WHITE and BLACK/GREEN wires in the wiring
harness from the connector of the turn indicator switch.
ELECTRIC WINDOWS For total window roll up time set the alarm unit roll-up pulse to 24s.
CENTRAL DOORS LOCKING Negative control signal
Connect to the 0,75 mm2 YELLOW/BLUE lock wire and GREEN/RED unlock wire
in the wiring harness that runs from the push-button panel to the switch inside the
driver s door.
IMMOBILISATION POINT 1 Cut the 1 mm2 BLUE/YELLOW wire in the wiring harness that comes out of the 6
way light brown connector located on the connector plate under the dashboard on
the driver s side.
IMMOBILISATION POINT 2 Cut the 1 mm2 RED/VIOLET wire that comes off the fuse marked nr. 32 at the
fuse box above the left lateral bulkhead on the driver s side.
BONNET SWITCH Install an additional switch on the headlamp support grill, up on the left of the
headlamp on the driver s side.
DOORS SWITCH Connect to the 1 mm2 GREY/BLUE wire at position nr. 16 at the connector that
comes out of the central lock unit located under the dashboard on the driver s
side.
BOOT SWITCH Connect to the 1mm2 BROWN/BLACK wire in the wiring harness of the driver s
floor trim.
vogol98gbb.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.


Wyszukiwarka

Podobne podstrony:
VOGOL98GBD id 2134837 Nieznany
VOGOL98GBDT
VOGOL98GBD
VOGOL98GBBT
VOGOL98GBDT id 2134838 Nieznany

więcej podobnych podstron