CCNA4 v 4 0 Exam chapter 5 ACLs


CCNA4 v 4.0 Exam chapter 5 ACLs
1. By default, how is IP traffic filtered in a Cisco router?
blocked in and out of all interfaces
blocked on all inbound interfaces, but permitted on all outbound interfaces
permitted in and out of all interfaces
blocked on all outbound interfaces, but permitted on all inbound interfaces
2. Which three parameters can ACLs use to filter traffic? (Choose three.)
packet size
protocol suite
source address
destination address
source router interface
destination router interface
3. How do Cisco standard ACLs filter traffic?
by destination UDP port
by protocol type
by source IP address
by source UDP port
by destination IP address
4. Which two statements are correct about extended ACLs? (Choose two)
Extended ACLs use a number range from 1-99.
Extended ACLs end with an implicit permit statement.
Extended ACLs evaluate the source and destination addresses.
Port numbers can be used to add greater definition to an ACL.
Multiple ACLs can be placed on the same interface as long as they are in the same direction.
5. Where should a standard access control list be placed?
close to the source
close to the destination
on an Ethernet port
on a serial port
6. Which three statements describe ACL processing of packets? (Choose three.)
An implicit deny any rejects any packet that does not match any ACL statement.
A packet can either be rejected or forwarded as directed by the statement that is matched.
A packet that has been denied by one statement can be permitted by a subsequent statement.
A packet that does not match the conditions of any ACL statements will be forwarded by default.
Each statement is checked only until a match is detected or until the end of the ACL statement list.
Each packet is compared to the conditions of every statement in the ACL before a forwarding decision is made.
7. Which two statements are true regarding the significance of the access control list wildcard mask 0.0.0.7? (Choose two.)
The first 29 bits of a given IP address will be ignored.
The last 3 bits of a given IP address will be ignored.
The first 32 bits of a given IP address will be checked.
The first 29 bits of a given IP address will be checked.
The last 3 bits of a given IP address will be checked.
8. Which two statements are true regarding the following extended ACL? (Choose two.)
access-list 101 deny tcp 172.16.3.0 0.0.0.255 any eq 20
access-list 101 deny tcp 172.16.3.0 0.0.0.255 any eq 21
access-list 101 permit ip any any
FTP traffic originating from network 172.16.3.0/24 is denied.
All traffic is implicitly denied.
FTP traffic destined for the 172.16.3.0/24 network is denied.
Telnet traffic originating on network 172.16.3.0/24 is denied.
Web traffic originating from 172.16.3.0 is permitted.
9. Interface s0/0/0 already has an IP ACL applied inbound. What happens when the network administrator attempts to apply a
second inbound IP ACL?
The second ACL is applied to the interface, replacing the first.
Both ACLs are applied to the interface.
The network administrator receives an error.
Only the first ACL remains applied to the interface.
10. Refer to the exhibit. When creating an extended ACL to deny traffic from the 192.168.30.0 network destined for the Web
server 209.165.201.30, where is the best location for applying the ACL?
ISP Fa0/0 outbound
R2 S0/0/1 inbound
R3 Fa0/0 inbound
R3 S0/0/1 outbound
11. Which two statements are true regarding named ACLs? (Choose two.)
Only named ACLs allow comments.
Names can be used to help identify the function of the ACL.
Named ACLs offer more specific filtering options than numbered ACLs.
Certain complex ACLs, such as reflexive ACLs, must be defined with named ACLs.
More than one named IP ACL can be configured in each direction on a router interface.
12. Which three items must be configured before a dynamic ACL can become active on a router? (Choose three.)
extended ACL
reflexive ACL
console logging
authentication
Telnet connectivity
user account with a privilege level of 15
13. Refer to the exhibit. How does this access list process a packet with the source address 10.1.1.1 and a destination of
192.168.10.13?
It is allowed because of the implicit deny any.
It is dropped because it does not match any of the items in the ACL.
It is allowed because line 10 of the ACL allows packets to 192.168.0.0/16.
It is allowed because line 20 of the ACL allows packets to the host 192.168.10.13.
14. A network administrator needs to allow traffic through the firewall router for sessions that originate from within the
company network, but the administrator must block traffic for sessions that originate outside the network of the company.
What type of ACL is most appropriate?
dynamic
port-based
reflexive
time-based
15. Refer to the exhibit. How will Router1 treat traffic matching the time-range requirement of EVERYOTHERDAY?
TCP traffic entering fa0/0 from 172.16.1.254/24 destined to the 10.1.1.0/24 network is permitted.
TCP traffic entering fa0/0 from 10.1.1.254/24 destined to the 172.16.1.0/24 network is permitted.
Telnet traffic entering fa0/0 from 172.16.1.254/24 destined to the 10.1.1.0/24 network is permitted.
Telnet traffic entering fa0/0 from 10.1.1.254/24 destined to the 172.16.1.0/24 network is permitted.
16. The following commands were entered on a router:
Router(config)# access-list 2 deny 172.16.5.24
Router(config)# access-list 2 permit any
The ACL is correctly applied to an interface. What can be concluded about this set of commands?
The wildcard mask 0.0.0.0 is assumed.
The access list statements are misconfigured.
All nodes on the 172.16.0.0 network will be denied access to other networks.
No traffic will be allowed to access any nodes or services on the 172.16.0.0 network.
17. Refer to the exhibit. The administrator wishes to block web traffic from 192.168.1.50 from reaching the default port of the
web service on 192.168.3.30. To do this, the access control list name is applied inbound on the router R1 LAN interface. After
testing the list, the administrator has noted that the web traffic remains successful. Why is web traffic reaching the
destination?
Web traffic does not use port 80 by default.
The access list is applied in the wrong direction.
The access list needs to be placed closer to the destination, on R3.
The range of source addresses specified in line 10 does not include host 192.168.1.50.
18. Refer to the exhibit. What will be the effect of the configuration that is shown?
Users attempting to access hosts in the 192.168.30.0/24 network will be required to telnet to R3.
Hosts connecting to resources in the 191.68.30.0/24 network have an idle timeout of 15 minutes.
Anyone attempting to telnet into R3 will have an absolute time limit of five minutes.
Telnet access to R3 will only be permitted on Serial 0/0/1.
19. Which statement about standard ACLs is true
Standard ACLS must be numbered and cannot be named.
They should be placed as close to the destination as possible.
They can filter based on source and destination address as well as on source and destination port.
When applied to an outbound interface, incoming packets are processed before they are routed to the outbound interface.
20. Which benefit does an extended ACL offer over a standard ACL?
Extended ACLs can be named, but standard ACLs cannot.
Unlike standard ACLs, extended ACLS can be applied in the inbound or outbound direction.
Based on payload content, an extended ACL can filter packets, such as information in an e-mail or instant message.
In addition to the source address, an extended ACL can also filter on destination address, destination port, and
source port.
21. Which feature will require the use of a named ACL rather than a numbered ACL?
the ability to filter traffic based on a specific protocol
the ability to filter traffic based on an entire protocol suite and destination
the ability to specify source and destination addresses to use when identifying traffic
the ability to edit the ACL and add additional statements in the middle of the list without removing and re-creating the
list
22. A technician is creating an ACL and needs a way to indicate only the subnet 172.16.16.0/21. Which combination of network
address and wildcard mask will accomplish the desired task?
172.16.0.0 0.0.255.255
127.16.16.0 0.0.0.255
172.16.16.0 0.0.7.255
172.16.16.0 0.0.15.255
172.16.16.0 0.0.255.255
23. Which two statements accurately describe the characteristics of wildcard masks in an ACL? (Choose two.)
Wildcard masks are the inverse of the subnet mask.
The word "any" indicates that all corresponding bits must be matched.
The word "host" corresponds to a wildcard mask of 0.0.0.0 in an ACL statement.
A wildcard mask of 0.0.255.255 can be used to create a match for an entire Class B network.
A wildcard mask bit of 1 indicates that the corresponding bit in the address must be matched.
24. Refer to the exhibit. Which statement is true about ACL 110 if ACL 110 is applied in the inbound direction on S0/0/0 of R1?
It will deny TCP traffic to the Internet if the traffic is sourced from the 172.22.10.0/24 network.
It will not allow TCP traffic coming from the Internet to enter the network 172.22.10.0/24.
It will allow any TCP traffic from the Internet to enter the network 172.22.10.0/24.
It will permit any TCP traffic that originated from network 172.22.10.0/24 to return inbound on the S0/0/0 interface.
25. Refer to the exhibit. ACL 120 is configured inbound on the serial0/0/0 interface on router R1, but the hosts on network
172.11.10.0/24 are able to telnet to network 10.10.0.0/16. On the basis of the provided configuration, what should be done to
remedy the problem?
Apply the ACL outbound on the serial0/0/0 interface on router R1.
Apply the ACL outbound on the FastEthernet0/0 interface on router R1.
Include the established keyword at the end of the first line in the ACL.
Include a statement in the ACL to deny the UDP traffic that originates from 172.11.10.0/24 network.
26. Refer to the exhibit. The network administrator applied an ACL outbound on S0/0/0 on router R1. Immediately after the
administrator did so, the users on network 172.22.30.0/24 started complaining that they have intermittent access to the
resources available on the server on the 10.10.0.0/16 network. On the basis of the configuration that is provided, what is the
possible reason for the problem?
The ACL allows only the mail traffic to the server; the rest of the traffic is blocked.
The ACL permits the IP packets for users on network 172.22.30.0/24 only during a specific time range.
The ACL permits TCP packets only if a connection is established from the server to the network 172.22.0.0/16.
The ACL allows only TCP traffic from users on network 172.22.40.0/24 to access the server; TCP traffic from any other
sources is blocked.


Wyszukiwarka

Podobne podstrony:
CCNA4 v 4 0 Exam chapter 7 Addressing Services
CCNA4 v 4 0 Exam chapter 6 Teleworking
Cisco chapter 7 exam questions
Chapter 11 The Developer s Exam
chapter13
The Kama Sutra Part V Chapter 3
Cisco Press CCNP Routing Exam Certification Guide Appendix
Book 4, Chapter 8
Tagg J , The discliplinary frame Footnotes to Chapter 5 Pencil of history
3? EXAM LANGUAGE ELEMENTSfor students
Feynman Lectures on Physics Volume 1 Chapter
The Kama Sutra Part I Chapter 2

więcej podobnych podstron