ïż
STEERING GEAR AND LINKAGE DISASSEMBLY
STEERING GEAR AND LINKAGE DISASSEMBLY
B3E061432960W02
Caution
• Place copper plates, rag, or similar material in a vise, when securing the mounting bracket portion of the steering gear.
1. Disassemble in the order indicated in the table.
1
P/S angle sensor (LF only)
2
Floor seal
3
Oil pipe
4
Tie-rod end
(See Tie-rod End Disassembly Note.)
5
Locknut
6
Boot clamp
7
Boot band
8
Boot
9
Tie rod
(See Tie Rod Disassembly Note.)
10
Locknut (on adjusting cover)
(See Locknut (on Adjusting Cover), Adjusting Cover Disassembly Note.)
11
Adjusting cover
(See Locknut (on Adjusting Cover), Adjusting Cover Disassembly Note.)
12
Yoke spring
13
Support yoke
14
Housing cover
15
Locknut (on pinion shaft)
16
Pinion shaft and valve housing component
17
Return pipe
18
Clip
19
Stopper
20
Steering rack
21
Rack bushing
22
Oil seal
(See Oil Seal Disassembly Note.)
23
Mounting rubber
(See Mounting Rubber Disassembly Note.)
24
Gear housing
Tie-rod End Disassembly Note
1. Place alignment marks as shown in the figure for proper installation.
Tie Rod Disassembly Note
1. Fix the steering rack and remove the tie rod using the SST.
Locknut (on Adjusting Cover), Adjusting Cover Disassembly Note
1. Remove the locknut using the SST.
2. Remove the adjusting cover.
Oil Seal Disassembly Note
1. Install the SST (49 N032 319A) to the gear housing with the raised part facing up as shown in the figure.
2. Insert the SSTs (49 F032 303, 49 B032 323) into the valve housing side.
3. Remove the oil seal using a press.
Mounting Rubber Disassembly Note
• Press the mounting rubber out from the gear housing using the SSTs and a press.
Wyszukiwarka
Podobne podstrony:
B3E061432960W03B3E061001034W01B3E061401034W02B3E061432010W01B3E061467880T03B3E061432010W02B3E061432960W04B3E061432960W05B3E061432650W05B3E061432110T01B3E061401034T01B3E061432650W04B3E061467880T01B3E061432650W02B3E061467880T05B3E061401034T02B3E061432960W01B3E061432010T01B3E061432040W01więcej podobnych podstron