C5EF00F1 - 607
ADJUSTMENT HEADLAMPS
1 -
TOOLING
[1] Adjustment checking device, Type 432 mm
.
2 -
VEHICLE PREPARATION
Unload the vehicle,Check the fuel tank which should be half full
.
Remove any excessive accumulation of mud, snow or ice which could affect the ride height of the vehicle
.
Check the pressure of the tyres which must be inflated to the pressure specified by the manufacturer under normal road conditions
.
Park the vehicle on level ground, wheels straight ahead
.
Switch on the headlamps and check the operation of the load corrector by turning the adjusting knob and place it in the normal load position 0
.
IMPERATIVE :
for vehicles fitted with an automatic height adjuster (discharge bulb version), adjustment will be carried out with the engine running
.
Check the operation of the automatic height adjusters, headlamps on, exerting pressure at the rear of the vehicle and checking the stability of the beam
.
3 -
PREPARATION OF THE ADJUSTMENT CHECKING DEVICE AND ALIGNMENT WITH THE VEHICLE
Prepare the alignment bar (1) with the position locking lever (2) turned towards the adjustment checking device
.
Adjust the angle of the cell (3) near the vehicle using a leveller (4), and tighten the lever (5)
.
Move the adjustment checking device towards the headlamp
.
Pull out the retractable checking rod (6) until the green part appears
.
Place the point of the rod facing the centre line of the headlamp to be adjusted
.
Adjust the position of the alignment bar (1) which must be in contact with the wheels of the vehicle
.
Tighten the adjustment checking device position locking levers (7)
.
4 -
ADJUSTMENT OF THE HEADLAMP
Apply the adjustment checking device adjustment procedure in line with the equipment's instruction manual
.
Register the angle of the vehicle and stop adjustment at this stage on the control panel
.
Align the headlamp beam (A) slightly below the line of demarcation (B)
.
The adjustment is carried out
.
Wyszukiwarka
Podobne podstrony:
C5EF00F4C5EF00F1C5EF00F7C5EF00F5C5EF00F2więcej podobnych podstron