aquaring s e


®
AQUA RING S
CEILING MOUNT
DIGITAL PASSIVE INFRARED DETECTOR
aquaring_s_e 03/06
The microprocessor-based, fully digital AQUA RING S detector for ceiling mount
installation is characterized by high sensitivity and interference resistance. A dual
pyroelectric element is used in the detector. AQUA S can be supplied with AC or DC
24V voltage.
Figure 1. View of detector electronics board.
Explanations to Fig. 1:
1  terminals:
NC  relay (NC)
TMP  tamper contact
24V  supply input (AC/DC)
2  LED indicator. It lights red for approx. 2 seconds after movement is sensed by
the detector and the alarm relay activated (opening of the NC contacts). This
allows the installer to check the detector for correct functioning and to
approximately determine the protected area.
3  alarm relay.
4  pyroelement.
5  tamper contact.
6  fixing screw hole.
7  pins for setting detector operating parameters (see Table 1).
The detector is provided with a prealarm feature. The prealarm is indicated by
a short flash of the LED for approx. 120ms, but does not activate the relay. Activation
of the prealarm takes place when the detector registered disturbances in the
environment, which do not meet the alarm criterion. The prealarm sensitivity do not
depend on what sensitivity is set on the detector pins.
For 30 seconds after the power-up, the detector remains in the starting state, which
is signalized by a rapid LED blinking. Only then the detector enters its operational
readiness state.
Pins
- pins shorted
JP1 JP2 JP3
Low sensitivity
- pins open
Medium sensitivity
High sensitivity
LED indicator ON
LED indicator OFF
Table 1. Programming of working parameters.
1. Installation
The detector is designed for indoor installation.
Be careful so as not to soil or damage the pyroelement in the process of
installation.
1. Open the housing as shown on Fig. 2.
Figure 2. The opening of the housing.
2. Remove the electronics board.
3. Make suitable openings for screws and cable in the rear panel of the housing.
4. Pass the cable through the prepared opening.
5. Fix the rear housing panel to the wall or to the attached holder.
6. Fasten the electronics board.
7. Connect the leads to the corresponding terminals.
8. Using jumpers, set the working parameters of the detector (see Table 1).
9. Close the detector housing as shown on Fig. 3.
Figure 3. The closing of the housing.
2. Start-up
1. Switch the detector power on. The LED will start blinking (if the JP3 pins are
shorted).
2. When the detector enters the ready state (the LED will stop blinking), carry out the
detector range test, i.e. check that movement within the supervised area will
activate the alarm relay and lighting of the LED.
3. If necessary, change the detector sensitivity (pins JP1 & JP2).
3. Technical data
Nominal supply voltage ................................................................................ 24V AC/DC
Max. current consumption (Ä…10%) ...................................................... 27mA for 24V AC
......................................................14mA for 24V DC
Violation signaling time................................................................................................ 2s
Protected area:
when mounted at a height of 2.4m.................................................36m2
when mounted at a height of 3.7m.................................................80m2
Operating temperature range ........................................................................-10...+50°C
Detectable motion speed............................................................................... up to 3 m/s
Dimensions.................................................................................................... Å‚97x29mm
Recommended installation height ......................................................from 2.2m to 4.5m
The latest EC declaration of conformity and product approval certificates
are available for downloading on website www.satel.pl
SATEL sp. z o.o.
ul. Schuberta 79
80-172 Gdańsk
POLAND
tel. + 48 58 320 94 00
info@satel.pl
www.satel.pl


Wyszukiwarka

Podobne podstrony:
Aquarium Aquaristik Amtra Manual Phosphatreduct
Horoscope 12 Aquarius
Aqua Aquarius
aquaring s
aquaring
aquaring s io pl11
ewangelia aquariusa
aquaring s io pl09
aquaring io pl09
Aquarium Aquaristik Tetra Broschure Futter
Aquarion

więcej podobnych podstron