Christmas tree Ornament (2000)
By: Charles Esseltine
3.) Fold the model in half so
1.) Start white side up. Fold 2.) Fold the sides into the
That the end points meet.
in half. Unfold centerline.
Unfold
5.) Fold bottom over the
4.) Fold the top point to
edge of the colored section.
meet the new crease.
Unfold
6.) Fold down to form trunk.
Like this.
If you are using a LARGE
7.) Wrap the inner layers
piece of paper, you can add
around the trunk. Then flip
more pleats.
over.
8.) Zoom in. Fold the bottom
9.) Pleat
tip upwards. Tuck the tip under
the front edge.
10.) Let's take a close look at one of the
lower pleats. Swivel fold the corner, so
that a small bit of the tip falls below the
bottom edge..
11 b.) Swivel fold complete.
11 a.) Swivel fold to narrow
the point. Leave the tip
below the edge alone.
12.) Now repeat steps 10 and
11 on the other side.
13.) Squash one of the
upper pleat tips. This is
similar to step 10, but this
one goes to the tip.
13a.) Swivel fold the ends,
14b.) Swivel fold complete.
15.) Now repeat steps 13 and
to make the point sharper..
14 on the other side.
16.) Pleats complete! Now flip
17.) Fold the model, at a right
the model over, and look at it
angle, down the centerline
from the bottom.
18.) Soft crease the ends so
that the model forms a tripod
base, that the model will stand
on.
To turn it into an ornament add a bit
of twisted wire to the point at step 7.
Wyszukiwarka
Podobne podstrony:
package treepackage treepackage treepackage treepackage treeTreeThe Fir TreeTree Journeyman 200 M187 79package treepackage treepackage treepackage treeFools Garden Lemon Treewięcej podobnych podstron