49586 Suzuki RM250
1-10 GENERAL INFORMATION
STOPPING THE ENGINE
1) Shift the transmission into neutral.
2) Tum the fuel valve lever to the “OFF” position.
3) Push the engine stop switch (2) to stop the engine.
A WARNING
Leaving the fuel valve in the “ON” position may cause carburetor overflow. This can cause a tire or severe engine damage when you start the engine.
Always leave the fuel valve in the “OFF” position when the engine is not running.
TRANSMISSION
This motorcycle has a 5-speed transmission. Neutral is located between Iow and 2nd. Engage first gear by pressing the lever down from the neutral position. You can shift into higher gears by lifting on the shift lever once for each gear. When neutral is desired, press or lift the lever to the position halfway between Iow and 2nd gear.
\
\
\ V N \\ \ \ >
BREAK-IN (RUNNING-IN)
WHEN THE MOTORCYCLE IS NEW
1) Warm up the engine befofe-sfartihg1 off:
2) Ride for 1 hour using less than1/2fthrottle opening with vari-ous throttle opening.
3) Ride for 1 hour using less than 3/4 throttle opening with vari-ous throttle opening.
NOTĘ:
* The break-in (running-in) period is the period ofgreatest wear.
* The bolts and nuts ot the new machinę can ioosen quick(y. Be surę to retighten the boits and nuts during the break-in (run-ning-in) period.
V\ V
I \ V
\
WHEN ENGINE PARTS ARE REPLACED
Follow the same procedurę when any of the following parts are replaced:
Piston Piston ring Cylinder Crankshaft Crankshaft bearing
Wyszukiwarka
Podobne podstrony:
Suzuki RM250 9 14 GENERAL INFORMATION A WARNING * Proper semce and repair procedur
46902 Suzuki RM2506 10-4 COOLING SYSTEMWATER PUMP • Drain the engine coolant. (CZ
suzuki rm25006 10-4 COOLING SYSTEMWATER PUMP • Drain the engine coolant. (d7“ 2-1
Faculty of Electrical Engineering GENERAL INFORMATION The Faculty of Electrical Engineering was esta
suzuki rm25008 10-6 COOLING SYSTEMREASSEMBLY Reassemble and remount the water pump in the reverse o
70714 Suzuki RM250? 9-10 FUEL SYSTEMCARBURETORREMOVAL AND DISASSEMBLY • Remove the
Suzuki RM2508 10-6 COOLING SYSTEMREASSEMBLY Reassemble and remount the water pump in the reverse or
Suzuki RM250 5 SYMBOL Listed in the table below are the symbols indicating instructions and other in
suzuki rm25018 EXHAUSTVALVE 11-9 Disassemble the governer assembly by pushing down the retainerINSP
suzuki rm25023 12-4 CONSTRUCTIONS • Remove the handlebars.REMOUNTING Remount the handlebars in the
72111 Suzuki RM2508 EXHAUSTVALVE 11-9 • Disassemble the governer assembly by pushing down the retai
więcej podobnych podstron