MR293R190�5 1

US1J9G ANTI-GRAVEL MASTIC

PrepaTation

Thoroughly raix the two coiriponents (parts A and B).

For Che products' optimum ąualities to be maintained, it ie important that che two components should be mixed in the correct proporcione^ that is co say:

-    all part A mixed with all part B;

-    half part A raixed with half part B.

Pot lLfe

The mix reraains usable for 1 hour at arabient temperaturę.

Application

For the mastic to adhere properly to bare panelling it must be preceded by one coat of chrome phosphatc primer and one coat of surfacer,

Apply the mastic in auccessive coats

Anti-gravel pressure apray gun (Pipo 2 type)

(A) An eztruded fillet of mastic is obtained by adjusting the gun as follows:

-    unscrew *screw (1);

-    close the air delivery screw (2);

-    unscrew the product delivery screw (3) by three turns.

To spray the mastic on to body siils, rear end panels, radiator grilles, whecl arches, adjust the gun as follows:

-    unscrew screw (1);

-    unscrew screw (2) by one and a half turns;

-    unscrew screw (3) by three turns.

(b) To spray the mastic on to any type of joint, adjust the gun as follows:

-    unscrew screw (1);

- unscrew screw (2) by one turn;

- unscrew screw (3) by two and a half turns-

The gun is to be cleaned after application-

MAY BE PAINTEO TMMEDIATELY WITH TWO-POT PAINT (poLyurethanc).    ~'|

Wyszukiwarka

Podobne podstrony:
MR293R190?9 1 TAILGATE FRAME 1    Before spraying on the anti-gravel mastic* you
MR293R190?4 1 Paint join mastic    7701421 212 Aoti-gravel mastic    7
MR293R19018 1 Id-i fig i conti nued) 0 D = 6 mm CONłTECTTON WTTH THE BODY SILI. AND WHEEL ARCH Thic
MR293R19025 1 Unpicking COMPOSITION OF PART AS SUPPLIED BY PARTS DEPARTMENT Panel only The two cove
MR293R19077 1 Dlsconneot the battcry, remove the luggage compartment carpet and the lefthand and ri
MR293R19084 1 1    - Remove the Tor* type screw and pla3tic oap located in the base
MR293R19086 1 Part no. 77 01 407 419 In the SONHATCH II rangę only roof 77 01 407 419 i3 rec-oamend
MR293R190&9 1 Remove the trim. Electric lock REHOYING THE LOCK The method for removing the two locks
MR293R190 4 1 RENOYAŁ Adjustlng the striker piąte. Remove the two screws (1) and puli the lock, turn
MR293R190)3 1 REMOTAL Using a fiat screwdriver, raise oover (1) at the ends of the strip. Puli the s
MR293R190)5 1 REHOVAL 2HD TTPE Using a suction pad, remove the gla3S {dęlicate operation). REFITTING

więcej podobnych podstron