262
Transverse Link Assembly
aSSEMBLY
REMOVAL
When installing upper and iower end of coi! spring on strut, it must be located and oriented as shown below.
1. Remove drive shaft.
Refer to Front Axle.
2. Remove Iower bali joint
using T00|
HT72520000 (J25730 A).
— Upper end
Smali
dia.
Large
dia.
I
B
A
INSPECTION
• Check bali joint for play. If bali stud is worn
and piay in axial direction is excessive or joint is hard to swing, replace transverse link assem-biy. r r?
SEA561
Turning torque:
"A" 0.15-3.43 N-m
(1.5-35 kg-cm, 1.3 - 30.4 in-lb) "B" 0.15-3.43 N-m
(1.5 - 35 kg-cm, 1.3 - 30.4 in-lb)
Axia! play:
"C" 0.5 mm (0.020 in)
• Check condition of dust cover. If it is cracked excessively, replace transverse link assembly.
• Check rubber bushing for damage, cracks and deformation; replace transverse link if neces-sary.
• Check transverse link for damage, cracks, deformation; replace transverse link if neces-sary.
FA-12
Wyszukiwarka
Podobne podstrony:
p41 (13) Install gasket and timer head tension (ground) spring on timer shaft base assembly and inse
skanuj0266 NORA 2 shutcles Make the upper and lowcr part of the wing one by one and join them&n
010 11 M*«n Winę AssembN M»n Wmg Installaoon 013 017 I - — 1 1
Follow this w i ring diagram when assembling the PCB. Take care with the orientation of the capacito
SMREAR DRUM BRAKE (LT18B) ___Removal and Installation- of Adjuster When installing, measure inner di
img357 Comment Assembly Label Oper Oper ation and If: LODD aO /Unneccessary S
suziki rm12507 GEARSHIFTING 9-5 GEARSHIFTING 9-5 Align the pin groove ® with the pin © when install
suziki rm12596 17-6 REAR SUSPENSION 17-6 REAR SUSPENSION • Install the dust seals. NOTĘ: When insta
The platform assembly shown in the figurę has a weight WL = lkN and center of gravity at Gv If it is
p62 (2) • ILLUS.51 TRANSMISSION—SHOWING ALL PARTS IN CORRECT ORDER OF ASSEMBLY Illustrations 51 and
The 264 fuel rods are bundled with grids, and the fuel assembly is * equipped with to
p62 (2) • ILLUS.51 TRANSMISSION—SHOWING ALL PARTS IN CORRECT ORDER OF ASSEMBLY Illustrations 51 and
File0005 (2) Mains Figurę 7. Wiring diagram - mains and PSU transformer secondary winding. When inst
Suzuki RM1256 17-6 REAR SUSPENSION • Install the dust seals. NOTĘ: When installing the dust seat, t
Suzuki RM1256 17-6 REAR SUSPENSION • Install the dust seals. NOTĘ: When installing the dust seat, t
więcej podobnych podstron