8342936743

PROGRAM ROZWOJOWY

^1 POLITECHNIKI WARSZAWSKIEJ

1) The torque is proportional to the square of the current, hence the current can be unipolar to produce unidirectional torque. Only one power switch per phase winding is required.

2) The torque constant is given by the slope of the inductance vs. rotor position characteristic (SRM will not have a steady-state equivalent Circuit in the sense that the DC and AC).

3) Since the torque is proportional to the square of the current, this machinę resembles DC series motor and has a good starting torque.

4) Direction of rotation can be reversed by changing the sequence of stator excitation.

5) Torque and speed control is achieved with converter control.

6) SRM required controllable converter.

7) Mutual coupling between phases is practically absent. Short-circuit fault in one phase winding has no effect on the other phases (application in aircrafts, nuclear power plant coolant pumps).

8) One power switch per phase winding implies no shooting-through failure.

On the base of simplified equation (1.12) and the linear phase self-inductance distribution in respect with rotor position (Fig. 1.2) there is possible to find angular rotor positions of possible positive, negative and zero torque generation.

1.2. EQUIVALENT CIRCUIT

The mathematical model of SRM is highly non-linear due to magnetic saturation influence on the i/ĄO,i) curve family but it allows for phase - torque superposition as the interaction between phases is minimal.

As SRM has doubly saliency, stator (phase) coordinates are mandatory. The phase (subscript j is used for denominating one motor phase) equations are:

r_sij +—--—

^{s J} dt

(1.14)

with the family of curves ^{6,ij) obtained for one phase only (as the periodicity is 7t/N_s). These curves may be obtained either through theory or through tests. Analytical or finite element methods are used for the scope. Accounting for magnetic saturation and air gap flux fringing is mandatory in all cases.

The motion equations (assuming rotor moment of inertia J and neglecting bearing loses and friction) are:

(1.15)

(1.16)

dW_t(i,d)

dÓ '

UNIA EUROPEJSKA

EUROPEJSKI FUNDUSZ SPOŁECZNY

_ dco _ _ Ad

J-=^Te-^Tload; - = <»,

dt dt

with T, = ; Ti = Ajfy,j(0,i.)di. =

Materiały dydaktyczne dystrybuowane bezpłatnie.

Projekt współfinansowany ze środków Unii Europejskiej w ramach Europejskiego Funduszu Społecznego