SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL X
BMW Z 4 03 DIESEL
MAKE MOD. YEAR
ALARM/SIREN Install the compact alarms and the sirens on the wheelhouse, passenger s side.
POSITION
Position the modular sistems and the modules under the dashboard, passenger s side.
CENTRAL UNIT POSITION
POWER SUPPLY +30: connect to the 3 mm2 RED wire in a multiway connector, passenger s side.
-31: connect to the ground terminal located behind the driver s side bulkhead.
IGNITION WIRE +15/54: connect to the VIOLET/WHITE wire, in the wiring harness coming out of the black
tripolar connector near the fuse box. As alternative: connect in the wiring harness coming out
of the connector of the ignition key.
DIRECTION INDICATORS Connection with separate lines
Connect to the BLUE/GREEN wire at the position nr.50, BLUE/YELLOW wire at the position
nr.18, BLUE/GREEN wire at the position nr.1, BLUE/BROWN wire at the position nr.11,
BLUE/YELLOW wire at the position nr.3 and BLUE/BROW wire at the position nr.43, in the 54
way black connector coming out of the position and low beam lights control switch.
Note: Separate the lines with 1N4004 diodes.
ELECTRIC WINDOWS Negative control signal
Connect to the wire that actuates the comfort system of the vehicle directly in the wiring
harness coming out of the door switch inside the driver s side door.
CENTRAL DOORS LOCKING Negative control signal
Connect both the OPEN/CLOSE (VIOLET and ORANGE) wires of the antitheft to the
YELLOW/RED wire located in the 5 way black connector coming out of the open/close original
push-button located in the central tunnel.
IMMOBILISATION POINT Fuel pump
Cut the 1,5 mm2 BROWN/YELLOW wire in the wiring harness coming out of the brown relay
located in the fuse box, in the black box in the driver s side engine compartment.
STARTER +50: Cut the 3 mm2 BLUE/BLACK wire in the wiring harness coming out of the connector of
the ignition key.
BONNET SWITCH Install an additional switch on the headlamp support plate, near the original bonnet bumper
rubber.
DOORS SWITCH Connect to the BROWN/BLUE wire coming out of the lamp in the passenger s side. The signal
is with positive polarity.
BOOT SWITCH Connect to the wire that activates the boot lamp, directly inside the boot.
HORN CONTROL Positive control
Connect to the VIOLET/BLUE wire in the wiring harness coming out of the connector in
vertical position located in the frontal part of the fuse box.
bmz403gbb.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
Wyszukiwarka
Podobne podstrony:
530 2003 petrol NOZ4 2003 petrol YESA4 2003 petrol NO166 T S 1998 petrol NOSerie 7 2003 diesel NOGT 2004 petrol NOPT CRUISER 2001 petrol NOA4 2001 petrol NOX 5 2001 petrol NOA2 2004 2°sem 1 petrol NOwięcej podobnych podstron